Cisco MDS 9000 Series

To remove an existing fan module, follow these steps:
Step 1 On the fan module that you are removing, press the two sides of the fan module handle next to where it connects to the
fan module and pull on the handles enough to unseat it from its connectors.
Step 2 Holding the handle, pull the module out of the chassis.
Do not touch the electrical connectors on the back side of the module and prevent anything else from coming
into contact with and damaging the connectors.
Caution
Installing the Cisco MDS 9148T Switch
21
Installing the Cisco MDS 9148T Switch
Removing a Fan Module