To Next PageTo Next Page
Need help?Do you have a question about the Cisco MDS 9148T and is the answer not in the manual?
General| Ports | 48 |
|---|---|
| Port Type | Fibre Channel |
| Form Factor | 1RU |
| Switching Bandwidth | 1536 Gbps |
| Power Supply | Dual, hot-swappable |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Storage Temperature | -40°F to 158°F (-40°C to 70°C) |
| Management | CLI |
| Dimensions | 1.72 x 17.3 in |
| Humidity | 5% to 95% non-condensing |
Introduction to the guide's audience, organization, and conventions.
Details the prerequisite knowledge for using the installation guide.
Explains the formatting and symbols used in the document.
Lists other Cisco documents relevant to the MDS 9000 Series.
Guidance on accessing Cisco documentation and support.
Introduces the switch's features, capabilities, and architecture.
Describes the front view of the switch and its components.
Details components visible on the rear and side of the switch.
Explains physical chassis components, fan modules, and power supplies.
Explains the status indicators (LEDs) on the switch panels.
Specifies general and specific requirements for cabinets and racks.
Details airflow and perforation requirements for perforated cabinets.
Lists specific requirements for solid-walled cabinets, focusing on airflow.
Covers preinstallation steps and the optional Telco/EIA shelf bracket kit.
Step-by-step guides for installing the shelf bracket in Telco and EIA racks.
Covers site prep, airflow, power, and general installation guidelines.
Instructions for unpacking and checking the switch for damage.
Steps to ensure Network Equipment-Building System (NEBS) compliance.
Guides for installing the switch in 4-post and 2-post racks.
Covers ESD, grounding, power, and fan module handling.
Considerations for site preparation and network connectivity.
Connecting the console port to PCs and modems.
Connecting management Ethernet and Fibre Channel ports.
Procedures for installing, removing, and maintaining SFP transceivers and cables.
Instructions for powering up the switch and verifying component installation.
Details environmental and physical specifications for the switch.
Lists power supply ratings and airflow requirements.
Provides sample power dissipation data for the AC power supply.
Lists cables and adapters included in the accessory kit.
Describes the console port, its pinouts, and connection methods.
Details the Out-of-Band Ethernet Management Port.
Information on supported power cords and fibre cable specifications.
Checklist for evaluating and preparing the installation site.
Worksheet for recording essential contact and site details.
Worksheet for recording chassis and network configuration data.
