Cisco MDS 9148T User Manual

If you do not order a power cord with the system, you are responsible for selecting the appropriate power cord
for the product. Using a noncompatible power cord with this product may result in electrical safety hazard.
Orders delivered to Argentina, Brazil, and Japan must have the appropriate power cord ordered with the
system.
Caution
Standard Power Cords
Cisco standard power cords for the Cisco MDS 9148T switch have an IEC C15 connector on the outlet end
of the cord and a country specific plug on the inlet end of the cord. To see the list of supported standard power
cords, see the Cisco MDS 9148T 32-Gbps 48-Port Fibre Channel Switch Data Sheet.
Jumper Power Cord
Jumper power cords have an IEC C15 connector on the outlet end of the cord and an IEC C14 connector on
the inlet end of the cord. This cord is compatible with IEC C13 outlet receptacles. This type of outlet receptacle
is commonly used for power distribution inside cabinets.
To see the list of supported jumper power cords, see the Cisco MDS 9148T 32-Gbps 48-Port Fibre Channel
Switch Data Sheet.
Fibre Cable Specifications
For information on the fibre cable specifications, see the Cisco MDS 9000 Family Pluggable Transceivers
Data Sheet.
Cisco MDS 9148T 32-Gbps 48-Port Fibre Channel Switch Hardware Installation Guide
60
Cable and Port Specifications
Standard Power Cords

Cisco MDS 9148T Specifications

General

Brand	Cisco
Model	MDS 9148T
Category	Switch
Language	English