APPENDIX A
Cable and Port Specifications
This appendix includes information about the cables and connectors used with the Cisco MDS 9148T Multilayer
Fabric Switch.
We strongly recommend that power cable runs and other potential noise sources be located as far away as
practical from network cabling that terminates at Cisco equipment. In situations where long parallel cable
runs exist, but cannot be separated by at least 3.3 ft. (1 m), we recommend that you shield these potential
noise sources. To avoid interference, the source should be shielded by housing it in a grounded metallic
conduit.
Caution
• Cables and Adapters, on page 55
• Console Port, on page 56
• Out of Band Ethernet Management Port, on page 57
• Supported Power Cords and Plugs, on page 59
Cables and Adapters
The Cisco MDS 9148T Switch accessory kit includes the following:
• RJ-45-to-RJ-45 rollover cable
• RJ-45-to-DB-9 female DTE adapter (labeled Terminal)
• RJ-45-to-DB-25 female DTE adapter (labeled Terminal)
• RJ-45-to-DB-25 male DCE adapter (labeled Modem)
Additional cables and adapters can be ordered from your customer service representative.
Note
If you purchased this product through a Cisco reseller, contact the reseller directly for technical support. If
you purchased this product directly from Cisco, contact Cisco Technical Support at
http://www.cisco.com/c/en/us/support/index.html.
Note
Cisco MDS 9148T 32-Gbps 48-Port Fibre Channel Switch Hardware Installation Guide
55
To Next Page
Loading...
Need help?
General
