1. Place the ceiling grid clip over the T-rail and close it to the appropriate detent (A, B, or C).
2. Use a screwdriver to tighten the two ceiling grid clip locking screws to prevent the clip from sliding along the T-rail.
Note: The T-Rail mount attachment (AIR-AP-T-RAIL-R) has two included screws pre-installed to lock the T-Rail mount to
the actual T-Rail so it will not slide back and forth. These two screws are not to be confused with the #6-32 x 1/4 screws
in a separate bag for mounting the universal bracket to the T-Rail mount (steps 4 and 5 below).
14
To Next Page
Loading...
