Wall Mount the AP using Universal Mounting Bracket
To mount the AP on the wall, first identify the location of the wall
1. Use the mounting bracket as a template to mark the locations of the mounting holes on the bracket
2. Use a 0.1360-in. [3.4772 mm] bit to drill a pilot hole at the mounting hole locations you marked.
3. Locate the pilot holes and then insert a fastener(not included) into each mounting hole and tighten.
4. Place the universal mounting bracket over the faster holes and then use screws up to 6 mm in diameter and at least 1
- 1/4 inch length (not included) to tighten it flush to the wall
17
To Next Page
Loading...
