Cisco NCS 1002 User Manual

The following example shows sample output from the show sdr command in Cisco IOS XR EXEC mode.
RP/0/RP0/CPU0:ios# show sdr
RP/0/RP0/CPU0:ios#sh sdr
Tue Nov 10 22:57:20.921 UTC
Type NodeName NodeState RedState PartnerName
--------------------------------------------------------------------------------
RP 0/RP0/CPU0 IOS XR RUN ACTIVE NONE
NCS1K-CNTLR-K9 0/RP0 OPERATIONAL N/A
The following example shows sample output from the show sdr command in system admin EXEC mode.
sysadmin-vm:0_RP0# show sdr
Tue Nov 10 22:56:41.225 UTC
sdr default-sdr
location 0/RP0/VM1
sdr-id 2
IP Address of VM 192.0.0.4
MAC address of VM E2:3A:DD:0A:8D:03
VM State RUNNING
start-time 2020-11-06T10:41:52.340092+00:00
Last Reload Reason FIRST_BOOT
Reboot Count 1
Step 2 admin
Enters system admin EXEC mode.
Example:
RP/0/RP0/CPU0:ios# admin
Step 3 show platform
Displays information and status for each node in the system.
Example:
sysadmin-vm:0_RP0# show platform
Tue Feb 27 10:26:58.763 UTC
Location Card Type HW State SW State Config State
----------------------------------------------------------------------------
0/0 NCS1002 OPERATIONAL N/A NSHUT
0/RP0 NCS1002--RP OPERATIONAL OPERATIONAL NSHUT
0/FT0 NCS1K-FTA OPERATIONAL N/A NSHUT
0/FT1 NCS1K-FTA OPERATIONAL N/A NSHUT
Verify that all the modules of the NCS 1002 are displayed in the result. The software state and the hardware state must
be OPERATIONAL.
The various hardware and software states are:
Hardware states:
• OPERATIONAL—Node is operating normally and is fully functional
• POWERED_ON—Power is on and the node is booting up
• FAILED—Node is powered on but has experienced some internal failure
• PRESENT—Node is in the shutdown state
Troubleshooting Guide for Cisco NCS 1002, IOS XR Release 6.3.x
5
General Troubleshooting
Verifying the Status of Hardware Modules

Cisco NCS 1002 Specifications

General

Brand	Cisco
Model	NCS 1002
Category	Network Hardware
Language	English