PurposeCommand or Action
(Optional)
Configures the minimum interval allowed between PTP
delay messages when the port is in the master state.
[no] ptp delay-request minimum
interval [aes67 | smpte-2059]
log-seconds
Step 8
Example:
switch(config-if)# ptp
delay-request minimum interval
aes67 -1
Table 6: PTP Delay-Request Minimum Interval Range and
Default Values
Default ValueRangeOption
0 log seconds
–4 to 5 log
seconds
aes67
0 log seconds
–4 to 5 log
seconds
smpte-2059
0 log seconds
–1 to 6 log
seconds (where
–1 = 1 frame per
second)
Without the
aes67 or
smpte-2059
option
(Optional)
Configures the interval between PTP synchronization
messages on an interface.
[no] ptp sync interval [aes67 |
smpte-2059] log-seconds
Example:
switch(config-if)# ptp sync
interval aes67 1
Step 9
Table 7: PTP Synchronization Interval Range and Default
Values
Default ValueRangeOption
–2 log seconds–4 to 1 log
seconds
aes67
–2 log seconds–4 to –1 log
seconds
smpte-2059
–2 log seconds–3 to 1 log
seconds
Without the
aes67 or
smpte-2059
option
Cisco Nexus 9000 Series NX-OS IP Fabric for Media Solution Guide, Release 7.0(3)I4(2)
17
Configuring IP Fabric for Media
Configuring PTP for Media
To Next Page
Loading...
