CHAPTER 4
Connecting the Switch to the Network
• Setting Up the Management Interface, on page 29
• Uplink Connections, on page 29
• Connecting to Host Servers, on page 29
• Guidelines for Connecting Ports, on page 30
• Maintaining Transceivers and Optical Cables, on page 31
Setting Up the Management Interface
Before you begin
The switch must be powered on.
What to do next
You are ready to connect the interface ports on each of the line cards to the network.
Uplink Connections
For a list of transceivers and cables used by this switch for uplink connections, see
http://www.cisco.com/c/en/us/support/interfaces-modules/transceiver-modules/products-device-support-tables-list.html.
Statement 1051—Laser Radiation
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
view directly with optical instruments.
Warning
Connecting to Host Servers
To determine which transceivers and cables are supported by this switch, see
http://www.cisco.com/c/en/us/support/interfaces-modules/transceiver-modules/products-device-support-tables-list.html.
Cisco Nexus 9364C-H1 NX-OS Mode Switch Hardware Installation Guide
29
To Next Page
Loading...
