Cisco ONS 15454 M12 - NTP-G795 Change System Mode Using LCD

Figure 20: Attaching Plastic Lower Backplane Cover
Step 5 Tighten the five retaining screws that hold the plastic cover in place.
Stop. You have completed this procedure.
NTP-G795 Change System Mode Using LCD
For ONS 15454 M2 and 15454 M6, the system mode can be changed from ANSI (SONET) to ETSI (SDH)
or vice-versa. Changing the system mode removes the provisioned data and the system reverts to the default
configuration.
Maintaining the ONS 15454 M12 (ANSI and ETSI), ONS 15454 M2 and ONS 15454 M6 Shelf
30
Maintaining the ONS 15454 M12 (ANSI and ETSI), ONS 15454 M2 and ONS 15454 M6 Shelf
NTP-G795 Change System Mode Using LCD