Administration
Hardware Resources
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 89
6
the reload takes place at the specified time on the current day (if the specified time
is later than the current time) or on the next day (if the specified time is earlier than
the current time). Specifying 00:00 schedules the reload for midnight. The reload
must take place within 24 days.
NOTE This option can only be used if the system time has either been set manually or
by SNTP.
NOTE If a reboot is scheduled, click Cancel Reboot to cancel the scheduled reboot.
- In—Reboot within the specified number of hours and minutes. The maximum
amount of time that can pass is 24 days.
• Restore to Factory Defaults—Reboots the device by using the factory default
configuration. This process erases all except the Active Image, Inactive Image, Mirror
configuration and Localization files
The stack unit ID is set to auto.
• Clear Startup Configuration File—Check to clear the startup configuration on the
device for the next time it boots up.
Hardware Resources
The Hardware Resources page enables you to adjust the Router TCAM allocation for policy-
based routing (IPv4 and IPv6) and VLAN mapping rules. It also enables you to view the status
and to re-activate hardware-based routing.
If you change the router TCAM allocation incorrectly, an error message is displayed. If your
router TCAM allocation is feasible, a message is displayed that an automatic reboot will be
performed with the new settings.
Routing resources can be modified incorrectly, in one of the following ways:
• The number of router TCAM entries for a specific entry type that you allocate is less
than the number currently in use.
• The total number of router TCAM entries that you allocated is greater than the
maximum available.
To Next Page
Loading...
Need help?
General
