Access Control
IPv6-Based ACL Creation
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 582
26
- IGMP Type to match—Number of message type that is to be used for filtering
purposes.
STEP 5 Click Apply. The IPv4-based ACE is saved to the Running Configuration file.
IPv6-Based ACL Creation
The IPv6-Based ACL page displays and enables the creation of IPv6 ACLs, which check pure
IPv6-based traffic. IPv6 ACLs do not check IPv6-over-IPv4 or ARP packets.
NOTE ACLs are also used as the building elements of flow definitions for per-flow QoS handling.
IPv6-Based ACL
To define an IPv6-based ACL:
STEP 1 Click Access Control > IPv6-Based ACL.
This window contains the list of defined ACLs and their contents
STEP 2 Click Add.
STEP 3 Enter the name of a new ACL in the ACL Name field. The names are case-sensitive.
STEP 4 Click Apply. The IPv6-based ACL is saved to the Running Configuration file.
IPv6-Based ACE
NOTE Each IPv6-based rule consumes two TCAM rules.
STEP 1 Click Access Control > IPv6-Based ACE.
This window contains the ACE (rules) for a specified ACL (group of rules).
STEP 2 Select an ACL, and click Go. All currently-defined IP ACEs for the selected ACL are
displayed.
STEP 3 Click Add.
STEP 4 Enter the parameters.
To Next Page
Loading...
