Cisco SPA1112 - Page 106

Voice Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 106
6
<G726-32_Enable_1_> through <G726-
32_Enable_13_>
To enable the use of the G.726 codec at 32 kbps, select yes.
Otherwise, select no.
Default setting: yes
<Silence_Threshold_1_>
<Silence_Threshold_2_>
<Silence_Threshold_5_> through
<Silence_Threshold_13_>
Select the appropriate setting for the threshold: high, medium,
or low.
Default setting: medium
<FAX_V21_Detect_Enable_1_>
<FAX_V21_Detect_Enable_2_>
To enable detection of V21 fax tones, select yes. Otherwise,
select no.
Default setting: yes
<Echo_Canc_Enable_1_> through
<Echo_Canc_Enable_13_>
To enable the use of the echo canceller, select yes. Otherwise,
select no.
Default setting: yes
<FAX_CNG_Detect_Enable_1_>
<FAX_CNG_Detect_Enable_2_>
To enable detection of the fax Calling Tone (CNG), select yes.
Otherwise, select no.
Default setting: yes
<FAX_Passthru_Codec_1_> through
<FAX_Passthru_Codec_2_>
Select the codec for fax passthrough, G711u or G711a.
Default setting: G711u
<FAX_Codec_Symmetric_1_> through
<FAX_Codec_Symmetric_2_>
To force the ATA to use a symmetric codec during fax
passthrough, select yes. Otherwise, select no.
Default setting: yes
<DTMF_Process_INFO_1_> through
<DTMF_Process_INFO_13_>
To use the DTMF process info feature, select yes. Otherwise,
select no.
Default setting: yes
<FAX_Passthru_Method_1_> through
<FAX_Passthru_Method_2_>
Select the fax passthrough method: None, NSE, or ReINVITE.
Default setting: NSE
<DTMF_Process_AVT_1_> through
<DTMF_Process_AVT_13_>
To use the DTMF process AVT feature, select yes. Otherwise,
select no.
Default setting: yes
<FAX_Process_NSE_1_> through <FAX_
Process_NSE_2_>
To use the fax process NSE feature, select yes. Otherwise,
select no.
Default setting: yes