Router Configuration Parameters
<WAN_VLAN_Setting> Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 167
7
<WAN_VLAN_Setting> Parameters
This section describes the parameters in the <WAN_VLAN_Setting> section of the
config.xml file.
NOTE In addition to the descriptions, also refer to <WAN_VLAN_Setting> Example:
VLAN Enabled with ID 100, page 168.
Parameter Details
<WAN_VLAN_Enable> Description: Enables or disables a VLAN on your network
User Interface: Network Setup > Advanced Settings > VLAN page,
Enable VLAN field
Values:
0: Disabled
1: Enabled
Default: 0
Example: VLAN enabled
<WAN_VLAN_Enable>1</WAN_VLAN_Enable>
<WAN_VALN_ID> Description: A number that identifies the VLAN
User Interface: Network Setup > Advanced Settings > VLAN page,
VLAN ID field
Values: 1~4094
Default: 1
Example: VLAN ID 100
<WAN_VALN_ID>100</WAN_VALN_ID>
To Next Page
Loading...
