Cisco SPA1112 - Cldp_Setting> Parameters

Router Configuration Parameters
<CLDP_Setting> Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 168
7
<WAN_VLAN_Setting> Example: VLAN Enabled with ID 100
<router-configuration>
...
<WAN_VLAN_Setting>
<WAN_VLAN_Enable>1</WAN_VLAN_Enable>
<WAN_VALN_ID>100</WAN_VALN_ID>
</WAN_VLAN_Setting>
...
</router-configuration>
<CLDP_Setting> Parameters
This section describes the parameters in the <CLDP_Setting> section of the
config.xml file.
NOTE In addition to the descriptions, also refer to <CLDP_Setting> Example: CDP, LLDP,
and Layer 2 logging enabled, page 169.
Parameter Details
<CDP_ENABLE> Description: Enables or disables Cisco Discovery Protocol
User Interface: Network Setup > Advanced Settings > CDP &
LLDP page, Enable CDP field
Values:
0: Disabled
1: Enabled
Default: 0
Example: CDP enabled
<CDP_ENABLE>1</CDP_ENABLE>