Cisco SPA1112 - Wan_Interface> WAN Interface Parameters

Router Configuration Parameters
<WAN_Interface> WAN Interface Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 149
7
<WAN_Interface> WAN Interface Parameters
This section describes the parameters in the <WAN_Interface> section of the
config.xml file.
TIP: You can click the <WAN_Interface> heading in the XML file to expand or
collapse the nested parameters in this section.
NOTE In addition to the descriptions, also refer to WAN Example 1: DHCP with automatic
MTU mode, page 153, WAN Example 2: Static IP with manual MTU mode,
page 154, and WAN Example 3: PPPoE with Connect on Demand, page 154.
Parameter Details
<WAN_Connection_Type> Description: Defines the connection/addressing mode used for the
INTERNET (WAN) port.
User Interface: Network Setup > Basic Setup > Internet Settings
page, Connection Type field
Values:
• dh: DHCP
• st: Static
• pp: PPPoE
Default: dh
Example: Static connection type
<WAN_Connection_Type>st</WAN_Connection_Type>