Cisco SPA1112 - Page 190

Router Configuration Parameters
<Web_Management>
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 190
7
<Web_Management> Example: Remote Management and
Remote Upgrade enabled
<router-configuration>
...
<Web_Management>
<Web_Utility_Access_HTTP>1</Web_Utility_Access_HTTP>
<Web_Utility_Access_HTTPS>1</Web_Utility_Access_HTTPS>
<Web_Remote_Management>1</Web_Remote_Management>
<Remote_Web_Utility_Access>1</Remote_Web_Utility_Access>
<Web_Remote_Upgrade>1</Web_Remote_Upgrade>
<Allowed_Remote_IP_Type>0</Allowed_Remote_IP_Type>
<Allowed_Remote_IP_Address>209.165.201.129 129</Allowed_Remote_IP_Address>
<Remote_Management_Port>443</Remote_Management_Port>
</Web_Management>
...
<Allowed_Remote_IP_Address> Description: Specifies a remote IPv4 address that is allowed access
to the web-based configuration utility, when Remote Management is
enabled
User Interface: Administration > Management > Web Access
Management page, Allowed Remote IPv4 Address field, unlabeled
text box
Values: IPv4 address
Default: 0.0.0.0
Example:
<Allowed_Remote_IP_Address>209.165.201.129 129</Allowed_Remote_
IP_Address>
<Remote_Management_Port> Description: Specifies the port to use for access to the web-based
configuration utility through the WAN interface (INTERNET port)
User Interface: Administration > Management > Web Access
Management page, Remote Management Port field
Values: port number
Default: 80
Example:
<Remote_Management_Port>443</Remote_Management_Port>
Parameter Details