Cisco SPA1112 - Page 93

Voice Parameters
Provisioning Guide for Cisco SPA100 and SPA200 Series Analog Telephone Adapters 93
6
<AVT_Dynamic_Payload> AVT dynamic payload type. The valid range is 96-127.
Default setting: 101
<INFOREQ_Dynamic_Payload /> INFOREQ dynamic payload type.
Default setting: blank
<G726r32_Dynamic_Payload> G726r32 dynamic payload type.
Default setting: 2
<EncapRTP_Dynamic_Payload> EncapRTP Dynamic Payload type.
Default setting: 112
<RTP-Start-Loopback_Dynamic_
Payload>
RTP-Start-Loopback Dynamic Payload type.
Default setting: 113
<RTP-Start-Loopback_Codec> RTP-Start-Loopback Codec. Select one of the following:
G711u, G711a, G726-32, G729a.
Default setting: G711u
<NSE_Codec_Name> NSE codec name used in SDP.
Default setting: NSE
<AVT_Codec_Name> AVT codec name used in SDP.
Default setting: telephone-event
<G711u_Codec_Name> G.711u codec name used in SDP.
Default setting: PCMU
<G711a_Codec_Name> G.711a codec name used in SDP.
Default setting: PCMA
<G726r32_Codec_Name> G.726-32 codec name used in SDP.
Default setting: G726-32
<G729a_Codec_Name> G.729a codec name used in SDP.
Default setting: G729a
<G722_Codec_Name> G.722 codec name used in SDP.
Default setting: G722
<EncapRTP_Codec_Name> EncapRTP codec name used in SDP.
Default setting: encaprtp