Copyright © 2005-2012 Jaguar Telecom Version 1.8 Page 2 of 8
1 Introduction
This document describes how to install the Cisco terminal adaptors.
This document is applicable to the following devices:
2 FXS Port Terminal Adaptor
We use a sophisticated auto provisioning system to pre-configure and test all the devices
we supply.
This has the following advantages:
• Easiest possible installation
• Elimination of configuration errors caused by mistyping
• The ability to seamlessly apply configuration and firmware updates
• The ability to apply custom and site specific changes to your configuration.
The document is in two parts, the first section is the setup of a new Cisco as supplied
pre-configured for your use
1.1 Shipping List
Cisco SPA112 (Terminal Adaptor)
UK Telephone Socket converters
1.2 Additional equipment required
• Operational Ethernet LAN with ADSL router providing Internet connectivity
• Standard UK telephone(s)
To Next Page
Loading...
