Cisco SPA112 Administration Guide

Administration Settings
Management
Cisco SPA100Series Administration Guide 112
5
Settings for SNMPv3
Trap Configuration
Field Description
Enabled, Disabled Click Enabled to enable this feature, or click Disabled to
disable it. The default setting is Disabled.
R/W User Enter the user name for SNMPv3 authentication. The
default value is v3rwuser.
Auth-Protocol Choose the SNMPv3 authentication protocol from the
drop-down list (HMAC-MD5 or HMAC-SHA).
Auth-Password Enter the authentication password.
PrivProtocol Choose a privacy authentication protocol from the drop-
down list (None or CBC-DES). If you select CBCDES, the
privKey encrypts the data portion of the message that is
being sent.
Privacy Password Enter the key for the authentication protocol to use.
Field Description
IP Address The IP Address of the SNMP manager or trap agent.
Port The SNMP trap port used by the SNMP manager or trap
agent to receive the trap messages. Valid entries are
162 or 1025~65535. The default value is162.
SNMP Version The SNMP version in use by the SNMP manager or trap
agent. Choose a version from the list.

Cisco SPA112 Specifications

General

Supported network protocols	IPv4, IPv6, ARP, DNS, SRV, DHCP, PPPoE, ICMP, TCP, UDP, RTP, RTCP, SNTP
DHCP client	Yes
VPN support	802.1p
Security algorithms	SSL/TLS
Authentication method	SIP
Modem (RJ-11) ports	2
Ethernet LAN (RJ-45) ports	1
Voice codecs	G.711, G.726, G.729
Certification	FCC, CE, ICES, A-Tick, RoHS, UL
Fax compatibility	T.38
Output current	2 A
Output voltage	5 V
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Storage temperature (T-T)	-25 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	101 mm
Height	28 mm
Weight	153 g