Cisco SPA122 Administration Guide

Administration Settings
Management
Cisco SPA100Series Administration Guide 112
5
Settings for SNMPv3
Trap Configuration
Field Description
Enabled, Disabled Click Enabled to enable this feature, or click Disabled to
disable it. The default setting is Disabled.
R/W User Enter the user name for SNMPv3 authentication. The
default value is v3rwuser.
Auth-Protocol Choose the SNMPv3 authentication protocol from the
drop-down list (HMAC-MD5 or HMAC-SHA).
Auth-Password Enter the authentication password.
PrivProtocol Choose a privacy authentication protocol from the drop-
down list (None or CBC-DES). If you select CBCDES, the
privKey encrypts the data portion of the message that is
being sent.
Privacy Password Enter the key for the authentication protocol to use.
Field Description
IP Address The IP Address of the SNMP manager or trap agent.
Port The SNMP trap port used by the SNMP manager or trap
agent to receive the trap messages. Valid entries are
162 or 1025~65535. The default value is162.
SNMP Version The SNMP version in use by the SNMP manager or trap
agent. Choose a version from the list.

Cisco SPA122 Specifications

General

Ports	2 FXS ports
Network Interface	10/100 Mbps Ethernet
Voice Protocol	SIP
Voice Codecs	G.711, G.726, G.729 A
Security	TLS
Power Supply	5V DC, 2A
Network Ports	1 x 10/100 Mbps
Fax Support	T.38 fax relay
Operating Temperature	0°C to 45°C
Storage Temperature	14 to 140°F (-10 to 60°C)
Humidity	10% to 90% noncondensing
Weight	0.16 kg