Configuring the Network
Application (SPA122 Only)
Cisco SPA100Series Administration Guide 37
3
VLAN
Use the Network Setup > Advanced Settings > VLAN page to assign a VLAN ID
to your network. For example, your call control system may require a particular
voice VLAN ID.
After making changes, click Submit to save your settings, or click Cancel to
redisplay the page with the saved settings.
CDP & LLDP
Device discovery protocols enable directly connected devices to discover
information about each other. You may wish to enable these protocols to allow
your network management system to learn about your ATA and endpoints. Use the
Network Setup > Advanced Settings > CDP & LLDP page to specify the settings
for Cisco Discovery Protocol (CDP) and the Link Layer Discovery Protocol (LLDP).
When a discovery protocol is enabled, the ATA sends periodic messages to a
multicast address and also listens to the periodic messages sent by other devices
that use that protocol.
After making changes, click Submit to save your settings, or click Cancel to
redisplay the page with the saved settings.
Application (SPA122 Only)
Use the Network Setup > Application pages to support voice service and any
servers that you host for public access.
• Quality of Service (QoS) (SPA122 Only)
• Port Forwarding (SPA122 Only)
• DMZ (SPA122 Only)
Field Description
Enable VLAN Click Enabled to enable a VLAN, or click Disabled to
disable this feature. Default setting: Disabled
VLAN ID The VLAN ID can be any numeral from 1 through 4094.
When VLAN is enabled, the default setting is 1.
To Next Page
Loading...
Need help?
General
