Cisco TelePresence Touch 10 User Manual

D1534509 Cisco TelePresence User Guide
Systems using Touch10
Produced: March 2018 for CE9.3
All contents © 2010–2018
Cisco Systems, Inc. All rights reserved
38
Camera
Control Own Camera
Existing camera presets can be
used right away during a call.
Your video system may have more
than one camera, for example one
camera showing the participants,
while another shows the whiteboard.
If you need to add new or modify
existing camera presets, this is
done in the same way as you do
outside a call. As an alternative
to adding or editing presets, a
simple adjustment of your camera’s
pan tilt and zoom should also be
considered.
About Editing Presets
In a call or outside a call (shown here),
tap Camera.
In a call or outside a call (shown here),
tap Camera.
Select the preset to use.
Tap anywhere outside the menu when
you’re done.
Adjust Pan, Tilt and Zoom. The
selfview will be temporarily turned
on to assist you.
1 2 3
4 5 6
Using your camera presets
Adjusting your camera’s pan, tilt and zoom
Tap anywhere outside the menu when
you’re done.

Cisco TelePresence Touch 10 Specifications

General

Resolution	1280 x 800
Touch Technology	Capacitive
Compatibility	Cisco TelePresence Systems
Power	Power over Ethernet (PoE)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Relative Humidity	10% to 90% (non-condensing)
Display Size	10.1 inches
Connectivity	Ethernet
Mounting	Tabletop
Weight	0.9 kg (1.98 lbs)
Storage Temperature	-20° to 60°C (-4° to 140°F)