Cisco UCS C200 - Power up the KVM

Power Up the KVM
Complete these steps in order to power up the server:
Plug the power cord into the chassis.
Note:
CIMC initializes system standby (Power Off mode).♦
CIMC is active and can be controlled through GUI or CLI, if you know the IP address.♦
1.
Depress Front Panel Power:
The Fans begins to spin up.♦
Then POST sequence begins.♦
At this point you can either boot up or begin the installation process.♦
Note that for large memory, models can display a blank screen for several minutes.♦
For C−250If you immediately depress the power switch, you interrupt the CIMC
initialization.
♦
2.