To Next PageTo Next Page
Need help?Do you have a question about the Cisco UCS C200 and is the answer not in the manual?
General| Form Factor | Rack-mountable |
|---|---|
| Processor | Intel Xeon 5500/5600 series |
| Memory | Up to 192GB DDR3 |
| Storage | Up to 8 x 2.5-inch drives or 4 x 3.5-inch drives |
| RAID Support | RAID 0, 1, 5, 10 |
| Network Interface | 2 x 10/100/1000 Ethernet ports |
| Management | Cisco Integrated Management Controller (CIMC) |
Information about the documentation set for Cisco Unified Computing System (UCS) C-Series rack-mount servers.
Information about the required familiarity with electronic circuitry and wiring practices for users.
Explains how the guide is structured by chapters and appendices.
Explains conventions used for notes, cautions, and safety warnings in the document.
Details on how to obtain documentation and submit service requests for Cisco products.
Steps to check the server shipment for completeness and damage after receiving it.
Guidelines for site preparation, space, airflow, and electrical requirements before server installation.
Detailed steps for mounting the server into a rack using slide rails and securing it.
Procedures for powering on the server, connecting to management, and configuring network settings.
Information on upgrading and accessing the system BIOS and CIMC firmware for server management.
Overview of tools like CIMC and Server Configuration Utility for server monitoring and management.
Explains the locations and interpretations of front and rear panel LEDs for status and troubleshooting.
Describes required equipment and procedures for safely shutting down and powering off the server for maintenance.
Instructions on how to remove and replace various hardware components within the server.
Lists the physical dimensions (height, width, depth) and weight of the Cisco UCS C200 server.
Details operating and non-operating environmental conditions like temperature, humidity, and altitude.
Lists AC input voltage, frequency, current, and output voltage for the server's power supplies.
Describes the KVM cable connection, its ports, and supported components for server management.
Lists various power cords supported by the server, including their specifications and illustrations.
Details supported RAID controllers, their internal drive capabilities, and necessary cables for LFF and SFF servers.
Steps to enable the integrated ICH10R RAID controller in the BIOS for SW RAID mode.
Instructions to enable the mezzanine RAID controller in Enhanced mode via BIOS setup.
Illustrates possible RAID controller connectors and recommended cable routing paths within the server.
Guidance on identifying the installed RAID controller by checking system boot messages.
Procedure to disable Quiet Boot in BIOS to view detailed boot messages and controller prompts.
Information on using host-based or LSI option ROM-based utilities to alter RAID configurations.
Steps to restore the RAID configuration to a new controller after replacing the original one.
Provides links to LSI utility help documentation and Cisco UCS Servers RAID Guide for further RAID information.
Directs users to external integration guides for Cisco UCS C-Series servers with UCS Manager.
