Cisco UCS C220 M3 Quick Start Guide

4
Cisco Security Manager 4.3 UCS Server Bundles Quick Start Guide
78-21007-01
BIOS Setup, OS Tuning, and Security Manager Tuning (these were done by Cisco before shipment of the Bundle to you)
Step 8 Do not update the BIOS; BIOS setup was done by Cisco before shipment of the Bundle to you; see BIOS
Setup, OS Tuning, and Security Manager Tuning (these were done by Cisco before shipment of the
Bundle to you), page 4.
Step 9 Do not update the CIMC firmware.
Step 10 Use the default username and password to log on to the OS; see Usernames and Passwords, page 6.
Step 11 Activate Windows. For more information, see Windows Activation, Product Key, and EULA, page 7
Step 12 Assign a static IP address to the server; see Assigning an IP Address, page 8.
Step 13 (Optional) Change the hostname; see Changing the Hostname, page 9.
Step 14 Ensure that required ports are enabled and available for use by Security Manager and its associated
applications on your server so that the server can communicate with clients and servers running
associated applications. For detailed information, refer to “Required Services and Ports” in the
“Requirements and Dependencies” chapter of the Installation Guide for Cisco Security Manager 4.3 at
the following URL:
http://www.cisco.com/en/US/docs/security/security_management/cisco_security_manager/security_ma
nager/4.3/installation/guide/requirem.html#wp1060450.
Step 15 Use the default username and password to log on to Cisco Security Manager; see Usernames and
Passwords, page 6.
Step 16 Install the Cisco Security Manager license; see the “Updating Security Manager” section of the
“Installing and Upgrading Server Applications” chapter of the Installation Guide for Cisco Security
Manager 4.3 at the following URL:
http://www.cisco.com/en/US/docs/security/security_management/cisco_security_manager/security_ma
nager/4.3/installation/guide/inserver.html#wp1053144.
Caution Your Cisco Security Manager license is provided in paper format and is packed in your shipping carton
along with your new Bundle itself. Please take care that it is not inadvertently discarded or lost.
Step 17 Refer, as needed, to the Related Documentation section of this “Quick Start Guide.”
BIOS Setup, OS Tuning, and Security Manager Tuning (these
were done by Cisco before shipment of the Bundle to you)
Before your new Bundle was shipped to you, Cisco set up the BIOS on the server, installed and tuned
the operating system, and installed and tuned Security Manager.
BIOS settings done in the Cisco UCS server (these were done by Cisco before shipment of the Bundle to
you):
• Intel Hyper-Threading Technology enabled.
• Virtualization disabled.
• Mass Storage Controllers Configuration selected.
RAID configuration (this was done by Cisco before shipment of the Bundle to you):
• Hardware RAID controller configured, with RAID 5 set up.
OS tuning and changes done in the Cisco UCS server (these were done by Cisco before shipment of the
Bundle to you):
• Disk cache policy configured.

Cisco UCS C220 M3 Specifications

General

Tcase	70 °C
Bus type	QPI
Stepping	M1
FSB Parity	No
Scalability	2S
Processor cache	10 MB
Processor cores	4
System bus rate	6.4 GT/s
Processor series	Intel Xeon E5-2600
Processor socket	LGA 2011 (Socket R)
Processor codename	Sandy Bridge EP
Processor frequency	2.4 GHz
Processor cache type	Smart Cache
Processor manufacturer	Intel
Processor package size	52.5 x 45.0 mm
Processor front side bus	- MHz
Processor boost frequency	2.50 GHz
Processor operating modes	64-bit
ECC supported by processor	Yes
Graphics & IMC lithography	32 nm
PCI Express configurations	x4, x8, x16
Supported instruction sets	AVX
Thermal Design Power (TDP)	80 W
Number of processors installed	2
CPU multiplier (bus/core ratio)	24
Physical Address Extension (PAE)	46 bit
Maximum number of PCI Express lanes	40
Memory types supported by processor	DDR3-SDRAM
Memory channels supported by processor	Quad
Memory clock speeds supported by processor	800, 1066 MHz
Memory bandwidth supported by processor (max)	34.1 GB/s
Maximum internal memory supported by processor	750 GB
HDD size	2.5 \
HDD interface	-
Total storage capacity	500 GB
Compatible memory cards	SD
Maximum storage capacity	- TB
Memory slots	16
Internal memory	32 GB
Memory clock speed	1866 MHz
Maximum internal memory	- GB
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Ethernet LAN (RJ-45) ports	3
Chassis type	Rack (1U)
Power supply	450 W
Safety	UL 60950-1 No. 21CFR1040, CAN/CSA-C22.2 No. 60950-1, IEC 60950-1, EN 60950-1, IEC 60950-1, AS/NZS 60950-1, GB4943 2001
Certification	47CFR Part 15 (CFR 47), AS/NZS CISPR22, CISPR2 2, EN55022, ICES003, VCCI, EN61000-3-2, EN61000-3-3, KN22, CNS13438, EN55024, CISPR24, EN300386, KN24
Operating altitude	0 - 3000 m
Non-operating altitude	0 - 12000 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 93 %
Operating relative humidity (H-H)	10 - 90 %
PCI Express slots version	3.0
Processor ARK ID	64588
Intel Secure Key Technology version	1.00
Intel Identity Protection Technology version	0.00
Harmonized System (HS) code	84714100

Weight and Dimensions

Depth	724 mm
Width	430 mm
Height	43.2 mm