1
Chapter 1: Valet
User Guide
Chapter 1: Valet
Thank you for choosing a Cisco Valet wireless hotspot. This Quick Reference Guide covers both the Valet and Valet Plus models.
Valet will be used as a general reference to both models and all details in this Quick Reference Guide apply to both models
unless Valet Plus is noted.
Top
LEDs (1-4) light up once the Valet is connected
to a device using a network (Ethernet) cable. The
LED flashes when there is activity over that port.
Valet Plus lights up green when connected to a device
at gigabit speed or blue when connected to a device at
10/100 speed.
The Wi-Fi Protected Setup Button doesn’t need to be
used if you use the Easy Setup Key to connect devices to
your network.
If you have client devices, such as wireless adapters, that
support Wi-Fi Protected Setup™, then you can use the Wi-Fi
Protected Setup button to automatically configure wireless
security for your wireless network(s).
To use Wi-Fi Protected Setup, refer to “Wi-Fi Protected
Setup” on page 21.
The Wireless LED lights up when wireless is on. It
flashes when the Valet sends or receives data over
the wireless network.
The Internet LED lights up when connected
to the Internet and flashes to indicate activity.
Valet Plus lights up green when connected to a
device at gigabit speed or blue when connected to
a device at 10/100 speed.
The Power LED lights up when the Valet
is powered on. It is normal for this to flash
during startup.
To Next Page
Loading...
Need help?
General
