Cisco WAP571 - Page 70

LAN
LLDP
Cisco WAP571/E Administration Guide 70
4
STEP 1 Select LAN > LLDP in the navigation area.
STEP 2 Configure the following parameters:
• LLDP Mode—TheadministrativemodeofLLDPontheAP.WhenLLDPisenabled,
theAPtransmitsLLDPProtocolDataUnitstoneighbordevices.
• TX Interval—ThenumberofsecondsbetweenLLDPmessagetransmissions.The
valid range is 5 to 32768 seconds. The default value is 30 seconds.
• POE Priority—The priority level transmitted by the AP in the Extended
Power information element. The PoE priority level helps the Power Sourcing
Equipment (PSE), such as a switch, determine which powered devices
should be given priority in power allocation when the PSE does not have
enough capacity to supply power to all connected devices. The PoE priority
can be one of the following:
- Critical
- High
- Low
- Unknown
STEP 3 Click Save. The settings are saved to the system.