Cisco Wide Area Virtualization Engine 594 and 694 - Chapter 5 WAVE Interface Modules; Interface Module Descriptions; Gigabit Ethernet Interface Module-Copper

CHAPTER
5-1
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
OL-24619-02
5
WAVE Interface Modules
This chapter describes Cisco WAVE Interface Modules and contains the following sections:
• Interface Module Descriptions, page 5-1
• Ports and LED Indicators, page 5-5
• Network Adapter Cabling Requirements, page 5-8
• Installation Scenarios and Cabling Examples for Fast Ethernet Connections, page 5-10
For information on installing an inline adapter in your WAVE-594 and WAVE-694, see the “Installing a
Cisco WAVE Interface Module” section on page 4-1.
For adapter specifications, see Table A-2 in Appendix A.
Interface Module Descriptions
The WAVE appliance supports one optional 4-port Copper Gigabit Ethernet Interface Module, 8-port
Copper Gigabit Ethernet Interface Module, 4-port Fiber Optic Gigabit Ethernet Interface Module, or
2-port SFP+ Fiber Optic 10 Gigabit Ethernet Interface Module.
This section contains the following topics:
• Gigabit Ethernet Interface Module—Copper
• Gigabit Ethernet Interface Module—Fiber Optic
• 10 Gigabit Ethernet Interface Module—Fiber Optic SFP+
• Inline Interface
Gigabit Ethernet Interface Module—Copper
The copper Gigabit Ethernet Interface Module is available in 4 or 8 ports. Both models support bypass.
(See Figure 5-1 and Figure 5-2.)