Cisco Wide Area Virtualization Engine 594 and 694 - Ports and LED Indicators

5-5
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
OL-24619-02
Chapter 5 WAVE Interface Modules
Ports and LED Indicators
Ports and LED Indicators
Figure 5-5 shows the 4-port Copper Gigabit Ethernet Interface Module port numbers, interface
designations, and LEDs. Figure 5-6 shows the same information for the 8-port adapter.
Figure 5-5 4-Port Copper Gigabit Ethernet Interface Module—Port Numbering and LEDs
Figure 5-6 8-Port Copper Gigabit Ethernet Interface Module—Port Numbering and LEDs
The Interface Module has an LED that corresponds to each port. Table 5-1 describes the LEDs.
Figure 5-7 shows the Gigabit Ethernet ports and LEDs for the 4-port and 8-port Copper Interface
Module.
246548
4 PORT BYPASS
0
1
2
3
Status
GE 0/1
GE 2/3
1 2
GE 0/1 GE 2/3 GE 4/5 GE 6/7
8 Port GE
Copper Inline
0
1
2
3
Status
0
1
2
3
Status
246548
1 2 2
Table 5-1 Copper Interface Module—Power and Status LEDs
LED Name Color State Description
1 Interface Module
power LED
Green On Interface Module is receiving power.
— Off Interface Module is not installed or a power
supply failure has occurred.
2 Bypass status Green Normal Indicates the inline port pair is in interception
mode.
Amber Bypass Indicates the inline port pair is in bypass
mode.
— Off No activity exists.