Citizen CH-456 - Loading the Batteries

- Eng 7 -
English
Español
Français Pyɫɫɤɢɣ
Ǒ¡Ûȣ
(Batteries supplied with the unit should be loaded in compartment before you use
the blood pressure monitor.)
1 Open the cover of battery compartment.
Pressing the hook down, pull the cover toward you to open.
2 Place batteries in the compartment.
Put the batteries paying attention to the positive
and negative terminal symbols
and .
• When the icon
is displayed or nothing appears in the display, replace the old
batteries with four new ones. All four batteries should be changed at once.
: The remaining capacity of the batteries is inadequate.
• Adjust the clock after changing the batteries.
• The data stored in the memory is not deleted by changing the batteries.
• Do not use rechargeable batteries.
• Do not use alkaline (LR6) and manganese (R6P) batteries together.
• Batteries included are for demonstration purposes only. Battery life may be
shorter than specified.
• When disposing of used batteries, comply with governmental regulations or
environmental public institution’s rules that apply in your country/area.
REMOVING THE BATTERIES
* If the Blood pressure monitor is
left unused for an extended period
of time, the batteries should be
removed from the compartment.
* When you install the batteries for the first time after purchase, the monitor will
display the clock setting screen. Follow step 2 and subsequent steps in TIME
ADJUSTMENT (
See page 9) to set the clock.
Battery cover
Lug (projecting
section)
Battery
compartment
Hook
4 “AA” batteries
Fit the lugs
(projections)
at the
recesses.
3 Close the battery cover.
Fitting the lugs of the cover at the mating
recesses of the battery compartment body,
push the hook to close the cover.
LOADING THE BATTERIES
00CH-456All.indbEng-72015/02/1918:51:38