-9-
Loading Media (For CL-S400DT)
(1) Press the cover open lever, and then open the printer cover.
Cover open
lever
(2) With scissors, cut the end of the media loaded in the media holder.
(3) Feed the end of the media through the cutter assembly until the end
extends 10 mm past the cutter cover.
(4) Close the Printer cover.
Approx. 10 mm
(5) The cutter will operate once when the FEED key on the control panel is
pressed.
CA
z When a paper jam has occurred, or when the auto cutter has
malfunctioned, your supplier or your service representative. Never
attempt to repair the auto cutter yourself, it could result in a risk of
injury.
To Next Page
Loading...
