Citizen CL-S400DT - Page 41

41
Chapter 2 Printer Operation
Top Menu Sub Menu Default Menu Remarks
Paper Position 0.00 inch
0.0 mm
Peel/Cut/Tear O
0.00 to 2.00 inch
0.0 to 50.8 mm
Peel/Cut/Tear On
-1.00 to 1.00 inch
-25.4 to 25.4 mm
Adjusts the stop position. It is based on the
inch/millimeter setting. There are initial
values of the stop position for each device
set above, and later, relative values are set.
Menu Key Action Enters Menu Enters Menu
Repeat Last One
Sets the menu key action.
Enters Menu:
Enters the menu setup mode.
Repeat Last One:
Last one is issued only for the nal page.
In the case of a count, afterwards, only
last one is issued.
Note: Hold down the MENU key for at least
4 seconds in order to enter the Menu Setup
Mode when setting the “Repeat Last One”
menu.
Interfaces RS-232C Baud 9600 115200
57600
38400
19200
9600
4800
2400
Setting the baud rate of the serial interface.
• All settings related to the interface are
enabled after the power is reconnected.
RS-232C Parity None None
Odd
Even
Setting the communication parity for the
serial interface.
RS-232C Length 8 bits 8 bits
7 bits
Setting the character length for the serial
interface.
RS-232C Stop bit
[RS-232C Stopbit]
1 bit 1 bit
2 bits
Setting the stop bit for the serial interface.
RS-232C X-ON Yes Yes
No
Selectively setting the X-ON ow control of
the serial interface.
IEEE1284 On On
O
Setting both direction of the Centro
Interface.
Web Monitor* Auto Auto
On
O
Selecting the web monitor function.
Network Address** 0.0.0.0 0.0.0.0 to
255.255.255.255
Setting xed IP address of the LAN board.
Subnet Mask** 0.0.0.0 0.0.0.0 to
255.255.255.255
Setting xed subnet mask value of the LAN
board.
Gateway Address** 0.0.0.0 0.0.0.0 to
255.255.255.255
Setting xed default gateway address of the
LAN board.
BOOTP** O On
O
Setting the BOOTP of the LAN board.
DHCP** O On
O
Setting the DHCP of the LAN board.
* Displayed when equipped with a SEH LAN board.
**Displayed when the Web Monitor is operating.
Mode Settings
[Zebra® Emulation]