Citizen CL-S400DT - Emulation Auto Detection

43
Chapter 2 Printer Operation
Emulation Auto Detect: Cross-Emulation
TM
Ordinarily emulation switching is conducted in the Menu Setup mode.
However, switching can also be conducted using the Emulation Auto-
Detection function outlined below.
The following message is displayed on the LCD when the Zebra®
emulation (ZPI2) command is detected during Datamax® emulation.
ZPI2 detected.
No Yes
Switch
No Yes
emulation?
No Yes
By selecting “Yes” the printer will reboot and automatically switch to ZPI2
emulation. The printer will return to the On Line Ready status if “No” is
selected.
The following message is displayed in the LCD when the Datamax®
command is detected during Zebra® emulation.
DMX detected.
No Yes
Switch
No Yes
emulation?
No Yes
By selecting “Yes” the printer will reboot and automatically switch to
Datamax® emulation (DM4/DMI/DPP). The printer will return to the On
Line Ready status if “No” is selected.