— 7 —
5 Setting/Replacing Paper Rolls
WARNING
● When opening the paper cover, take care not to touch the print head or cutter blade.
Otherwise, burning or injury of hand may result.
1. Pull the cover open button fully toward you.
2. Open the paper cover.
3. Insert a paper roll with is print area facing down
as shown in the figure and pull out the paper
end straightforward by several cm out of the
printer.
4. Close the paper cover until a click can be heard.
6 Self-printing
Insert paper into the printer. With the FEED switch pressed and held, turn the printer
power on, keep the FEED switch held for about 1 second, and then release the FEED
switch. The printer starts self-printing. The printer prints model name, version, DIP
switch setting, memory switch setting, and built-in fonts.
Memory
switch
setting
Serial communication
condition (Only serial
interface model)
DIP switch setting
(Only serial interface
model)
Firmware version
Interface
Buffer size
CAUTION!
● Always use the specified types of paper roll.
● Confirm that the paper roll is set correctly.
● When the paper is skewed and not extended straightforward from under the cover,
open the cover and adjust the paper correctly.
● When closing the cover, press on the center part of the cover to close it firmly.
● When setting paper, pay attention not to let your fingers get injured by the edge of
paper.
To Next Page
Loading...
