CTB serial bench scale service manual
8
6.5.3 Set check weighing mode
Press F key to enter setting mode, press TARE until display show “F4 OFF”, press
ZERO key to enter, press TARE key until display show “BEEP”, press ZERO key to
enter, press TARE key to select BP 2(check mode 2), BP3 (check mode 3), BP1(not
sound), press ZERO key to sure, press PRINT/M+ key to escape.
6.5.4 NOTE
The weight must be greater than 20 scale divisions for the check weighing to operate.
To disable the Check-Weighing function enter zero into both limits by pressing the
FUNC key when the current limits are shown then pressing ZERO/ENTER to store
the zero values.
6.6 Accumulated Total
The scale can be set to accumulate manually by pressing the PRINT key. See the
PARAMETERS Section for details of selecting the method using function "F5 P RT".
The accumulation function is only available when weighing. It is disabled during
parts counting.
The weight displayed will be stored in memory when the PRINT key is pressed and
the weight is stable.
The display will show "ACC 1" and then the total in memory for 2 seconds before
returning to normal. If the optional RS-232 interface is installed the weight will be
output to a printer or PC( this type machine has no print function).
Remove the weight, allowing the scale to return to zero and put a second weight on.
Press the PRINT key, the display will show "ACC 2" and then the new total.
Continue until all weights have been added.
To view the totals in memory press enter the PARAMETER SECTION and use
function "F1 TOL". See below.
6.7 Net/gross change
When you weigh, press N/G key , you can check net weight and gross weight.
To Next Page
Loading...
