VALUE
SEt Lo
Set a value for the Low limit. 000.000
F0 H-L
SEt HI
Set a value for the High Limit. 000.000
to CLr
Clears the accumulation memory
without printing the results.
to P-C
Prints the Accumulation memory
total and then clears the memory.
F1 toL
to Prt
Prints the Accumulation Total, does
not clear the memory.
bL
Set the backlight to be on,
automatic or off,
EL on
EL Au
EL off
EL Au
beep
Set the beep mode.(check weighing
mode 2, check weighing mode3, no
beep)
F2 off
sleep
Set the time of automatic sleep:
1,5,10,30 or OFF
10
Prog Pin
Enter the programming and
calibration menus by entering the
correct password. See the section
11.
To Next Page
Loading...
