2/2
E210 Abbreviated instruction
Using the chronograph
• Measuring up to 12 hours in 1/5 second increments.
1.
Push the crown in to position
0
.
2.
Start measurement.
Start/stop: press button
A
.
Reset: press button
B
while the chronograph is stopped.
• Be sure to reset chronograph after finishing measurement.
12 hours or more after starting measurement
As 12 hours have passed since measurement started, the chronograph hands stop
but measurement has not stopped. Reset the chronograph.
Using the alarm
• The alarm time is set in 12-hour basis.
1.
Pull out the alarm crown.
2.
Rotate the alarm crown to set the alarm time.
• Move the alarm indicator hand 30 minutes or so forward and move it back
to the time you want to set.
• The alarm may sound earlier or later (about ±5 minutes) than the time set.
Use the time set by the hand only as approximate reference.
3.
Push in the alarm crown.
The alarm time setting is finished.
• Press the alarm crown to set the alarm hand to “ON” if it points “OFF”.
To stop alarm
Press the alarm crown.
• The alarm sounds for 20 seconds.
To set the alarm ON/OFF
Each time you press the alarm crown, ON/OFF of the alarm changes alternately.
• The alarm sounds if it is set to “ON” again within 20 minutes after stopping it.
Resetting the watch — All Reset
Confirm the following before All Reset.
• The power reserve indication hand points level 3 or 2.
• The chronograph has been reset.
1.
Pull the crown out to position
2
when the second hand points
0 second.
2.
Press and release both button
B
and recessed button
C
at the
same time.
Alarm sounds and the power reserve indication hand move to level 3.
The reference position of each hand is adjusted automatically.
3.
Push the crown in to position
0
to finish the procedure.
The power reserve indication hand moves back and forward and the second
hand starts moving.
After All Reset
After All Reset, set the time and date indication. Set also the alarm.
To Previous Page
Loading...
Need help?
General
