Citizen E870 - Checking the Reference Position; Correcting the Reference Position; Resetting the Watch - All Reset

2/2
E870 Abbreviated instruction
Checking the reference position
1.
Change the mode to [L-TM] and push the crown in to position
0
.
2.
Press and hold the upper right button
B
for 10 seconds or
more.
The hands and indication start to move
to the current reference positions stored
in memory. Release the button as they
start moving.
3.
Check the reference positions.
Correct reference positions:
• Hour, minute and second hands: 0 hour
00 minute 00 second
• 24-hour hand: “24”
• Date indication: “1”
• Function hand: “SUN”
When the current reference position is different from the correct one,
proceed to step 3 of
Correcting the reference position
.
4.
Press and release the upper right button
B
to finish the
procedure.
• It returns to local time indication automatically in about 2 minutes without
pressing the button if you leave it without any operation.
Correcting the reference position
1.
Change the mode to [L-TM] and push the crown in to position
0
.
2.
Press and hold the upper right button
B
for 10 seconds or
more.
The hands and indication start to move to the current reference positions
stored in memory. Release the button as they start moving.
3.
Pull the crown out to position
2
.
4.
Press and release the upper right button
B
repeatedly to
change the hand/indication to be corrected.
• Each time you press the button, the target changes as follows:
Second hand → hour /minute/24-hour hands → function hand/date indication
→ (back to the top)
• The hands slightly move when selected to show they become adjustable.
5.
Rotate the crown to adjust the hand/indication.
• The hour, minute and 24-hour hands move synchronously.
• Date indication changes to the next as the function hand rotates 4 times.
Set the function hand to “SUN” directly after the date indication becomes
“1”.
• When you rotate the crown quickly, the hands/indication will move
continuously. To stop the rapid movement, rotate the crown in either
direction.
6.
Repeat steps 4 and 5.
7.
Push the crown in to position
0
to finish the procedure.
Resetting the watch - All Reset
1.
Change the mode to [L-TM] and pull the crown out to position
2
.
2.
Press and release both the lower right button
A
and upper
right button
B
at the same time.
As you release the buttons, the alarm sounds and all reset is executed.
The setting values after All Reset
Time of [TME]
0:00:00 AM
Time of [L-TM]
Time difference from [TME]: 0 hour
Calendar
January 1, Sunday of leap year
Alarm setting
“OFF”
Alarm time
0:00 AM
After All Reset
After All Reset, adjust the reference position and set the time and calendar and
other settings.
1