10
Before use
7 Checking the reference position
Check whether the reference position is correct or not.
Check and adjust the reference position
also in the following cases:
• The correct time is not displayed on
the analog section even after the time
setting.
• Each chronograph hand does not point
to “0/.00” or “60” even after resetting
the measurement time.
1. Press button M to change the
mode to Chronograph. (“CHR”)
Crown
Button A
Button B
Button M
“CHR”
Chronograph 1/10 second
and 1/100 second hands
Chronograph
second hand
To Next Page
Loading...
