________________________________________________________
48
Printing on Envelopes
We recommend that you set the VTOP option to +144 when
printing on envelopes. This starts your printing on the envelope—
not the flap. See "Top-of-Form Fine Adjustment" in this chapter for
more information on VTOP settings.
Figure 3-11. printable area for envelopes
Your printer is now ready. The printer waits between envelopes for
you to insert each new one and the control panel display reminds
you to load a new envelope by flashing the PAPER OUT indicator.
When printing on envelopes, avoid printing near edges of the
envelope or in areas where the paper is triple thickness {glued
together}. Figure 3-11 shows the recommended printable area of a
typical envelope.
To Next Page
Loading...
