55
1.
Pull the crown out to position
.
2.
Press the lower right buttons for seven or more seconds, then release them.
The second hand moves to the “0” second position, the hour hand and date
indication move slightly, and the watch is reset.
• If the hands do not move, perform step 2 again.
Troubleshooting
After performing All Reset
You must set the watch again following the procedure below.
1. Correct the current reference
position.
After performing All Reset, the watch
is in reference position correction
mode.
See from step 4 on page
48
.
2. Set the World Time.
See pages
18
to
25
.
3. Adjust the time/calendar.
• When adjusting by receiving the
time signal manually:
See pages
34
and
35
.
• When adjusting manually:
See pages
42
to
45
.
To Next Page
Loading...
