Why is my Citizen Watch not showing the correct time after successful reception?
If your Citizen Watch isn't showing the correct time and date after a successful time signal reception, verify that the World Time setting is correct. Also, check and correct the current reference position.
What to do if my Citizen H240 reception is unsuccessful?
If your Citizen Watch is not receiving a signal, make sure the crown is pushed in to position. Check the World Time setting. To improve reception, avoid potential interference and position the watch with the 9:00 position facing toward the station. Keep the watch still until reception is complete. If the second hand moves once every two seconds, charge the watch as it cannot receive the time signal in this state.
General| Brand | Citizen |
|---|---|
| Model | H240 |
| Category | Watch |
| Movement | Eco-Drive |
| Case Material | Stainless Steel |
| Band Material | Stainless Steel |
| Water Resistance | 100 meters |
| Crystal | Mineral |
| Case Thickness | 10 mm |
| Band Width | 20 mm |
| Calendar | Date |
| Functions | Date |
| Clasp | Fold-over clasp with safety |
Explains DANGER, WARNING, and CAUTION safety levels.
Procedure to set the watch to a specific city for local time.
Procedure to set time based on UTC time difference.
Solutions for issues with watch hand movement.
Remedies for inaccurate time or date display.
Troubleshooting time errors when settings are correct.
Step-by-step guide for performing a full watch reset.
Necessary steps after completing a watch reset.
Advice on regular recharging for optimal performance.
Warnings on charging at high temperatures or near heat sources.
Safety warnings regarding the rechargeable cell.
Warning against using non-specified batteries.
Chart of acceptable water activities for different resistance ratings.
Safety advice during watch wear and handling.
To Next Page