iDP3550/3551 User’s Manual
14
CITIZEN
4 .6.2 Using Fan-Fold paper (iDP3550P)
Setting the initial
1. Remove the printer cover.
2. Set the imprint face of the paper downward and put into the paper entrance.
3. If necessary to adjust the sprocket-wheel’s position, free the wheels using the lever
on both sides. Slide them to the appropriate position, and lock them back.
(See the left diagram of the below.)
4. Hook some of the paper’s perforations on the sprockets and forward the paper into
the printer mechanism by pulling and turning the paper -feed knob until the paper’s
tip reaches the platen. ( See the right diagram of the below.)
General using
1. Set the imprint face of the paper downward and put into the paper entrance.
2. Hook some of the paper's perforations on the sprockets and forward the paper into
the printer mechanism by pulling and turning the paper -feed knob.
Platen
Sprocket
(Pin tractor)
LOCK
FREE
Knob
Knob
To Next Page
Loading...
