46
Ease of use and comfort
Row 2 seat adjustments
Adjusting the angle of the backrest
Placing the backrest in the table
position
F Lower the head restraint fully.
F
Operate the control and adjust the angle.
F
Operate the control to fold the backrest onto
the seat cushion.
Rear seats (7 seats)
The seats in rows 2 and 3 are independent and
adaptable.
Each seat ca be removed and must be refitted
in the specified position, shown by a symbol on
its label.
Head restraint
This is of the rounded type.
High position: press the tab, lift and raise the
head restraint.
Low position: push the tab and press the top of
the head restraint to lower it.
To remove the head restraint: place it in the
high position, lift it, then remove it.
Store it inside the vehicle, securing it firmly.
To re-install the head restraint: engage the rods
of the head restraint in the holes, keeping it in
line with the backrest.
Types of row 2 seat
Types of row 3 seat
https://www.automotive-manuals.net/
To Next Page
Loading...
