50
Ease of use and comfort
Retting the seat
The seat label will tell you where it should be
placed.
F Lower the head restraint.
F
Place the seat in fully folded position.
F
Tilt the assembly forwards.
F
Take hold of each side of the uprights of the
folded seat while tilting it forwards and lift it.
F Place the hooks of the front feet between
the two bars.
F Ensure that no object or feet are obstructing
the rear anchorage points and that the seat
belt is properly positioned and available.
F
Fold the seat backwards to fix its rear
anchorage feet.
F Use the control to raise the backrest into the
initial position.
F Refit the head restraint.
Do not place hard or heavy objects on
the backrests forming a table. They could
become dangerous projectiles in the event
of emergency braking or collision.
Following the various operations:
-
do not remove a head restraint without
stowing it; secure it inside the vehicle,
- ensure that passengers can always
access the seat belts and fasten them
easily,
-
passengers must never take their seat
without adjusting and fastening their
seat belt.
-
a passenger seated in row 3 must
ensure that they do not obstruct the
row 2 seat anchorage points,
-
a passenger seated in row 3 must
not have the seat in front of them in
row 2 in the fully folded position; this
is in case the seat tips towards the
passenger unexpectedly, which could
cause injury.
Crew cab
Bench seat
The crew cab is made up of a bench seat for
3 persons, located in row 2, whose one-piece
backrest is integrated with the load stop grille.
Access to the rear seats is via the sliding side
door.
https://www.automotive-manuals.net/
To Next Page
Loading...
Need help?
General
