CITROEN C Zero - Page 102

Practical information
100
2. Ination
F Check that the compressor switch A is in
the "OFF" position.
F Uncoil the compressor pipe B.
F Connect this pipe to the valve of the
repaired wheel.
F Connect the compressor's electric plug to
the vehicle's 12 V socket (ignition switch in
position "ON" or "ACC").
F Start the compressor by turning the switch A
to the "ON" position.
F Using the compressor, adjust the pressure
in accordance with the vehicle's tyre
pressure label (located in the driver's door
aperture).
A loss of pressure indicates that the
puncture has not been fully plugged;
contact a CITROËN dealer or a qualified
workshop for assistance.
F Remove the compressor and stow the kit.
F Drive off straight away at reduced
speed (50 mph [80 km/h] max) limiting
the distance travelled to approximately
120 miles (200 km).
As soon as possible, go to a CITROËN
dealer or a qualified workshop.
Tell the technician that you have used
the kit. After checking, the technician
will advise you whether the tyre can be
repaired or must be replaced.
If after around 5 to 7 minutes the
pressure is not attained, this indicates
that the tyre is not repairable; contact
a CITROËN dealer or a qualified
workshop for assistance.