CITROEN C3 - Page 69

67
2
Acc ess
B618_en_Chap02_ouvertures_ed01-2016
Reinitialising the remote control
Following replacement of the battery or in the event of a remote control fault, it may be necessary to reinitialise the remote control.
F Switch off the ignition.
F Turn the key to position 2 (ignition on).
F Press the closed padlock button for a few
seconds.
F Switch off the ignition and remove the key
from the switch.
The remote control is now fully operational
again.
F Place the electronic key against the back-
up reader on the steering column and hold
it there until the ignition is switched on.
F If your vehicle has a manual gearbox, place
the gear lever in neutral then fully depress
the clutch pedal.
F If your vehicle has an automatic gearbox,
select position P then press the brake
pedal firmly.
Version without Keyless
Entry and Starting
Version with Keyless Entry and
Starting
F Switch on the ignition by pressing
the "START/STOP" button.
The electronic key is now fully operational
again.
If the fault persists after reinitialisation, contact
a CITROËN dealer or a qualified workshop
without delay.