113
Driving
6
Information displayed on
the instrument panel
5. Cruise control activated (green)/paused
(grey)
6. Speed setting value
7. Speed suggested by the Road signs
recognition
8. Vehicle held stationary
9. Inter-vehicle distance setting
10. Position of the vehicle detected by the
system
Use
Selecting the system
► With the engine running, press successively
on 1-ASSIST until cruise control mode is
displayed on the instrument panel.
► After a few seconds, cruise control mode is
selected. The Driving aids mini-view is displayed
(grey) and cruise control is ready to be activated.
Switching on cruise control
The vehicle speed must be between 0 and
112 mph (0 and 180 km/h).
System activation is also subject to the following
conditions:
– driver's door closed.
– driver's seat belt fastened.
– mode D selected on the automatic gearbox.
– parking brake released.
– if the vehicle is stationary, brake pedal
depressed.
The message “OK?" is displayed if all the
activation conditions are met.
► Press on 4-OK: the current speed becomes
the speed setting (minimum 19 mph (30 km/h))
and cruise control is immediately activated
(green display).
Modifying the speed setting
To change the speed setting using the vehicle’s
current speed:
► For steps of +/- 1 mph (1 km/h), make
successive short presses upwards/downwards
on 3 to increase/decrease.
► For steps of +/- 5 mph (5 km/h), press and
hold upwards/downwards on 3 to increase/
decrease.
Prolonged pressing and holding
upwards/downwards on 3 causes a rapid
change in vehicle speed.
When the function is activated, it is possible
to change the speed setting using the speed
suggested by the Road signs recognition
function displayed on the instrument panel:
– When passing the sign:
► Press 4-OK to save the suggested speed.
This value is then immediately shown as the new
speed setting on the instrument panel.
– After passing the sign:
► Press 4-OK. The message “OK?" is
displayed to conrm the request to save.
► Press 4-OK again to save the suggested
speed. The new speed setting value is displayed
on the instrument panel.
Pausing/resumption of cruise control
► Press 2-I I> or depress the brake pedal.
The symbol "I I>” is displayed if all the activation
conditions are met.
Cruise control may also have been paused:
– automatically, if the electronic stability control
(ESC) system is triggered.
– by shifting to neutral or engaging reverse gear.
– by using the electric parking brake.
– by unfastening the seat belt.
– by opening the driver's door.
► Press 2-I I> or 4-OK to reactivate cruise
control.
Following braking that has brought the vehicle
to a complete stop, if the trac conditions do
To Next Page
Loading...
