157
Practical information
7
risk of injury resulting from an automatic
change to START mode.
Rechargeable hybrid vehicles
Before any work is carried out under the
bonnet, it is essential to switch o the ignition
and disconnect the nozzle from the charging
connector if it is plugged in, check that the
READY indicator lamp is o on the instrument
panel and wait 4 minutes - risk of serious
injury!
The location of the interior bonnet
release lever prevents the bonnet being
opened when the left-hand front door is
closed.
When the engine is hot, handle the
exterior safety catch and the bonnet stay
with care (risk of burns), using the protected
area.
When the bonnet is open, take care not to
damage the safety catch.
Do not open the bonnet under very windy
conditions.
Cooling of the engine when stopped
The engine cooling fan may start after
the engine has been switched o.
Take care with objects or clothing that
could be caught in the blades of the fan!
Opening
► From the inside: pull the control lever,
located on the left below the dashboard, towards
you.
► From the outside: lift the safety catch and
raise the bonnet.
► Unclip the stay from its housing and place it
in the support slot to hold the bonnet open.
Closing
► Hold the bonnet and pull out the stay from the
support slot.
► Clip the stay in its housing.
► Lower the bonnet and release it near the end
of its travel.
► Pull on the bonnet and check that it is locked
correctly.
Because of the presence of electrical
equipment under the bonnet, it is strongly
recommended that exposure to water (rain,
washing, etc.) be limited.
To Next Page
Loading...
